Official site: satocard.io

USDT on TRC-20 or ERC-20: which network to use

TRC-20 and ERC-20 USDT are the same dollar on two networks. How they differ in fees and speed, and how to avoid sending to the wrong one.

Guide · Top-upsUpdated 3 min read

USDT is one stablecoin, but it travels on several networks. The two you will meet most are TRON, where it is called TRC-20, and Ethereum, where it is called ERC-20. The dollar is the same. The roads are not, and taking the wrong one is an expensive mistake.

Same coin, two networks

Think of USDT as a dollar bill and of a network as a postal service. TRON and Ethereum both deliver the same bill, but they do not share sorting centers. A package handed to one cannot be picked up at the other.

TRC-20 and ERC-20 are simply the names of the token standards on each network. USDT on TRON is a TRC-20 token. USDT on Ethereum is an ERC-20 token.

How they differ

USDT on TRON compared with USDT on Ethereum
USDT on TRON (TRC-20)USDT on Ethereum (ERC-20)
Address starts withT0x
Address length34 characters42 characters
Network fee paid inTRXETH
Size of the feeDepends on the energy the sending wallet holds. Often low, not always.Moves with how busy the network is. Sometimes lower than on TRON, sometimes much higher.
Usual waitOne to five minutes.Two to five minutes.

Both are fine for a card top-up. The right one is the one your wallet already holds.

How to tell which one you have

Look at your own receiving address for USDT in your wallet.

  • It starts with a capital T: your USDT is on TRON.
  • It starts with 0x: your USDT is on Ethereum, or on a network that copies Ethereum’s address format.

That second case deserves care. Several other networks use 0x addresses too, so an 0x address alone does not prove you are on Ethereum. Check the network name your wallet shows next to the balance.

You need the network’s own coin for the fee

A network fee is paid in the network’s coin, not in USDT. On TRON you need a little TRX. On Ethereum you need a little ETH. A wallet that holds only USDT cannot send it.

Exchanges hide this: they charge a flat withdrawal fee in USDT and pay the network themselves. That is convenient, but check whether the fee is added to the amount or taken out of it.

The three mistakes, and how to avoid them

  1. Sending on a different network from the one asked. The receiving page names one network. Send on that one. Between TRON and Ethereum, a wallet usually refuses the address and nothing leaves: take that as a warning, not as an obstacle to get around.
  2. Trusting the address format alone. This is the costly one. An 0x address is also valid on BNB Chain, Polygon, Arbitrum and others, and a wallet will happily send there. Choose the network first, then paste the address.
  3. Using a network that was not offered. USDT also exists on other networks. If the top-up page does not list one, it is not accepted, however cheap its fees.

What happens to a payment on the wrong network

It is not destroyed, but it arrives where the receiver is not looking, and often has no access. Sometimes it can be recovered by hand. Often it cannot. No support team can promise it.

Which one should you use?

For a SatoCard top-up, USDT is accepted on TRON and on Ethereum. Use the one you already hold, and for which you have the fee coin. If you hold neither yet, compare the withdrawal fees your exchange charges for each. The top-up page lists every coin and network accepted, and the top-up guide walks through a payment step by step.

Written by the SatoCard team. This page is general information, not legal, tax or financial advice. All guides

Your card is one top-up away.

No ID. No selfie. No paperwork. Limits and fees published before you start.

Welcome back

No account yet? Create one

You are on satocard.io